Penta taper - TSmithwick

OK - Here is Bill Fink's penta taper. It's a 7'3" 4-5 weight. It is very 
crisp and accurate, a wonderful DF rod. The numbers are the STRIP dimensions, 
ie. the planing form settings. Bill built this as a one piece, and I suggest 
you do the same if you possibly can. Can you do that on a Morgan Mill?  Maybe 
Bill would consider running a two piece taper for the vechicle length or 
planing form impaired?
0- .0305
5- .039
10-.050
15-.059
20-.066
25-.073
30-.080
35-.086
40-.092
45-.098
50-.105
55-.111
60-.117
65-.124
70-.130
75-.141
Balance   .151